Original version
Journal of Vacuum Science & Technology. A. Vacuum, Surfaces, and Films. 2020, 38 (4):042406, DOI: https://doi.org/10.1116/6.0000219
Abstract
Area-selective bottom-up synthesis routes of thin films are required to overcome the current limits in lithography, and such growth can be achieved with high quality and nanometer thickness control by area-selective atomic layer deposition (AS-ALD). However, the current range of materials demonstrated deposited by AS-ALD is limited, and no processes for molybdenum oxide have been available so far. In this work, the authors explore the properties of a new ALD precursor, MoCl4O, for deposition of molybdenum oxides by ALD. MoCl4O is administered at room temperature during deposition, making it readily available for use. When reacted with a combination of water and ozone, it leads to an AS-ALD process for deposition of MoOx—the first reported. The process is perfectly selective for growth on glass as compared to Si(100) substrates for deposition temperatures between 200 and 300 °C, with a growth rate of 0.72 Å/cycle at 300 °C. The process is attempted on a range of substrates proving good growth on soda-lime glass and LiF and no growth on Si(100), silica, Na2CO3, CaCO3, Li3PO3, or Li2SiO3. The findings of this study indicate an activated process by diffusion of sodium or lithium through the film during growth. The obtained films have further been characterized by x-ray photoelectron spectroscopy, scanning electron microscopy, x-ray diffraction, and atomic force microscopy, revealing films with an RSM roughness of 23 nm with the presence of crystalline MoO2 (C P/m) when deposited at 300 °C and crystalline Mo9O26 when deposited at 250 °C. The rough MoOx thin films may be applicable for electrocatalysis, gas sensors, or lithium-ion batteries. The findings of this study enable AS-ALD synthesis of molybdenum oxide with excellent selectivity not dependent on intermittent etching cycles during growth.